AUTONET TV

Put on the Brakes: Brake Service at Dennis Road Automotive

When it comes to preventive maintenance and vehicle care, most Dallas drivers know how important it is to check their brakes. But brakes are more than just brake pads and shoes. There are a lot of components in the brake system, and they all need to be in good working order.

The pads and shoes are known as the friction materials in the brake system. They push together, providing friction which stops the vehicle. It's no wonder they have to be checked regularly for wear, and brake pads and shoes need to be replaced periodically.

Brake pads/shoes gradually wear out, but that doesn't mean your braking gradually becomes less effective. The pads are engineered so that they maintain good braking until they wear too thin to provide adequate friction. At this point, they need to be replaced.

But your braking system also has mechanical parts. These pistons and springs can also gradually wear out or get gummed up by oil, dirt and other road spatter. A brake inspection at Dennis Road Automotive in Dallas  includes a check of these parts as well as the pads and shoes. Your friendly and knowledgeable pros at Dennis Road Automotive can then advise you of any parts that need cleaning or replacement.

The fluid component to the brake system needs a regular check-up at Dennis Road Automotive as well. The brake fluid cools and protects your brake system. Protective additives are gradually depleted by the operation of the brake system, and moisture buildup inside the fluid can diminish its effectiveness. When you have your brakes serviced at Dennis Road Automotive in Dallas, the fluid should be checked and, if needed, replaced, which will clean out water, debris and dirt.

It is important to remember that your brake system also includes your tires. No matter how well your brake system is performing, if your vehicle tires are worn, you won't get good stopping power. Traction is the power of your tires gripping to the roadway. Traction is always better on tires with a good tread. Good traction translates to good braking.

This is particularly important on wet Dallas roads. A good tire will give you good braking on either wet or dry TX roads. But stopping distance increases dramatically when worn tires meet wet roads. Tread on a tire acts to channel away water as the vehicle passes over the wet road, improving  contact between the tire's surface and the road; that maintains traction. But the thinner the tread, the less effective the water channels become, and water can get between the tire and the roadway, reducing friction. A loss of friction means a longer stopping distance and possibly the loss of control.

Braking depends on two things: the weight of your vehicle and the speed of the vehicle. The heavier the vehicle or the faster the vehicle, the more braking power it requires. Thus, brake systems vary from vehicle to vehicle. For example, a pickup that is designed for heavy loads has a more powerful braking system than a compact car. Sports cars also have higher-grade braking systems than minivans.

Regardless of what kind of car you drive in Dallas, it is always good auto advice to keep your brake system in good repair, and that means ALL of your brake system. Just one more way to keep your travels accident- and worry-free.

Dennis Road Automotive
11155 Dennis Road
Dallas, TX 75229
9722411901

Automotive Tips from Dennis Road Automotive: Serpentine Belt System Wear

The primary job of the serpentine belt for Dallas drivers is to provide important traction to spin the accessories. As the belt wears it loses some of its grip and the accessories may not spin at optimal speeds. For example, if your alternator doesn’t spin fast enough, the battery will not completely recharge while you’re driving and you could end up stranded around Dallas with a dead battery.

In short, a worn serpentine belt will stress all of the accessories it powers leading to premature wear and possible early replacement. When as little as 5% of belt material is lost, the serpentine belt cannot provide the proper traction for the accessories. Your friendly and professional Dennis Road Automotive service advisor can inspect your belt for excessive wear and replace your serpentine belt system if it’s excessively worn.

Give us a call.

Dennis Road Automotive
11155 Dennis Road
Dallas, TX 75229
9722411901

Saving Lives in Dallas with Tire Pressure

All new passenger vehicles on our Dallas, TX, roads now have tire pressure monitoring systems – TPMS for short. They are designed to alert you if your tires are underinflated. Since they are fairly new, a lot of people have questions about them.

First off, the most important thing is that you still need to check your tire pressure every week – or at least every time you gas up. The TPMS system alert comes in when your tire is 20 percent below the factory recommendation. So if the recommended pressure is 34 pounds per square inch, the TPMS warning won't come on until the pressure is at 28 pounds. That's significantly underinflated, enough to raise safety concerns.

The worst is tire failure. A severely underinflated tire can overheat and fail. Also, handling degrades to the point that you may not be able to steer out of trouble. Also underinflated tires wear out faster and they waste fuel. So it's costly to not stay on top of proper inflation.

What's the practical value of the TPMS system? Well, it's twofold. First, it can alert you when your tire is losing pressure due to a puncture or a bent rim. That's an important warning that you might not have gotten until next time you gassed up.

The second is that we all occasionally forget to check our tire pressure. So it's a fail-safe system to let you know there's a problem brewing.

Other things can cause your TPMS system to go off. The system also monitors itself. The sensors that are mounted in the wheels have little batteries that send a signal to the monitor. The batteries go dead over time and the TPMS system will let you know. And the sensors could break. Also road salt from our TX roads can ruin them.

There's also a hassle factor that your Dallas, TX, tire center has to contend with. For example, when you have your tires rotated in Dallas, the TPMS system has to be re-calibrated so that it knows which tire is on which corner of the car. Same is true for when you have new tires or winter tires installed. Flat repairs, as well.

That takes extra time. And it requires the right equipment and training. Special – and expensive – tire change machines need to be used with some sensors. It's all complicated by the fact that there are a number of different TPMS systems in use so the tire professionals at Dennis Road Automotive need equipment and training for each kind. Tire centers have had to raise the price of some of these basic services to offset their increased costs.

Also if you add custom wheels on your vehicle, you need to put in new TPMS sensors if your originals won't work on the new rims. If you don't your TPMS light will be on constantly and you won't have the benefit of the warning system.

All in all, the mandated TPMS systems will save lives, so they're worth the added hassle and expense.

Dennis Road Automotive
11155 Dennis Road
Dallas, TX 75229
9722411901

How to Radiate Cool (Radiator Care)

There's nothing that radiates cool like a vehicle radiator that's helping to keep your engine running at the proper temperature.  You don't have to baby it, but you can't simply ignore it, either. 

Let's take a quick dive under the hood to let you know what the radiator is doing.  It takes the heat your engine produces and moves that heat outside.  It's not an easy job and heat is an engine's number one enemy.  Now that you're thinking how nice you want to be to your radiator, we have a couple of ideas how you can take care of it.

The easiest thing is to pay attention to your vehicle's temperature gauge. If it gets in the "too hot" or "not hot enough" range, have it checked out soon.  Make sure your coolant is kept at the correct level and if you see a trend that you have to add coolant more than a couple of times a year, you might have a leak.

Even if there are no obvious problems, every couple of years or so, consider taking your vehicle in for radiator maintenance.  A technician can run a pressure check for leaks and ensure that the thermostat and radiator cap are working correctly.  The technician will check that fans are running like they should so they can move air over the radiator and heat away from the coolant inside.

Ask your service advisor when you should have your radiator flushed and coolant replaced according to the manufacturer's recommended intervals.  In addition to cooling, coolant has corrosion inhibitors which stop working after a while.  Without those corrosion inhibitors, the inside of your radiator can literally start rotting away.  Keep in mind that the coolant level must be kept at manufacturer's specifications since if those corrosion-preventing chemicals aren't touching the metal, they're not preventing corrosion. 

Different vehicles use different coolants, so your service facility will make sure yours is getting the correct one.  Keep your coolant system happy and one day, maybe you can order up a custom license plate, "RAY-D-8."

Dennis Road Automotive
11155 Dennis Road
Dallas, TX 75229
9722411901